30TP-412V - 30TP Series Steel Tele-Power Pole

Hi, We would not offer that as a standard part. If you need any additional information, please feel free to reach out to us directly at 1-844-957-3783, option 2 for Wiremold, followed by option 2 again for tech support.  Thanks,

Hello, The Panduit furniture bezel appears to not be compatible with the knockout on our plate. Two 30TC-CVR communication plates are installed on each pole. The rectangular knockout on each cover accepts modular furniture bezels. The rectangular knockout size measures 2.70" x 1.38". Please check with Panduit to get the appropriate furniture bezel size that'll fit the knockout size on our plate. Thank you

Hi, 30TP-AP would contain the ceiling hardware. If you are also looking for the bottom "boot" for the base of the pole that is part number E30-212. Thanks,

Hello Bruce, Standard keystone style jacks from most manufacturers fit the smaller knockouts on the communication plate. The rectangular knockout on the same plate fits a modular furniture bezel. Knockout size for the modular furniture bezel measures 2.70" x 1.38". Thank you

Hi Jim, You can use a blank pole and field punch KO's for a furniture feed. Thanks,

Hello, The 30TC-4 blank pole can be used to place receptacles at the needed height, and both sides can be used for power as long as there is no data/communication in the pole. You will also need 30TP-B add on plates and an additional V3010C entrance fitting. Here is a link to the cutsheet: https://legrand.webdamdb.com/directdownload.php?ti=55656446&tok=UQ8TPT/C1a/k33I8z5T7gQRR Thank you,

Hello, The power poles are mounted floor to ceiling, they attach to the ceiling grid, they do not need to go all the way up to the slab above the grid ceiling. All power poles include ceiling trim plates within their accessory packs.

The 30TP-4V poles come with (2) 20A, 120V duplex receptacles. Those can be replaced by L6-20R and L6-30R receptacles using a 30TP-J cover for each 20A or 30A locking device. The new receptacles will be mounted to the existing device brackets that hold the factory-wired duplexes. The 25DTP series poles also come with (2) 20A, 120V duplexes, but the duplexes cannot be replaced by 20A and/or 30A locking devices.