adorne® 700W sofTap™ Tru-Universal Dimmer

The universal dimmer has a 6W minimum load required and for WAC lighting(ELV), the dimmer should be put into Reverse phase.(see User Adjustments section on attached instruction link) https://legrand.webdamdb.com/directdownload.php?ti=55646800&tok=GcNt2dYl9SpC4XAf0iSV9gRR

Hello, When installing this Legrand dimmer in a 3-way it has to be installed on the load side and the switch needs to be on the line side. We are not able to identify the wires in the wall just what wires need to be connected on the back of this dimmer. Ground wire goes to green, Neutral wire goes to white, Hot goes to black, 3-way and 1 pole need to be matched up between the dimmer and switch. Please contact us at 844-957-3783 if you have any other questions. Thank you,

Yes, either one 3way switches can be replaced with the dimmer.

The Softap dimmer may need to be adjusted for the under cabinet lights you are controlling. If they are ELV(electronic low voltage), you need to put the dimmer into reverse phase. These steps are included with the dimmer instructions: SP/3Way true universal dimmer phase settings….FORWARD or REVERSE: You need to be in the minimum trim level adjustments to change the dimmer phase. To enter Min Level Trim: Hold Rocker button down for approximately 10s after minimum brightness reached. Bargraph LEDs will turn on to indicate cal mode activated. Releasing button within 5 seconds activates automated Min Level Trim feature as described in Initial Turn-on section below. Continuing to hold button for approximately 5 more seconds causes the +/- LEDs to flash, and initiates manual calibration. (basically hold for approx 15 secs until the +/- start flashing) Forward or Reverse Phase Selection Forward Phase is the default as shipped from factory. During manual Min Level Trim, holding On/Off button for approximately 10s toggles between Forward and Reverse Phase. The LED flash rate during calibration is approximately 1Hz for Reverse Phase, approximately 3Hz for Forward Phase. FORWARD phase – FAST blink REVERSE phase – SLOW blink

I would try resetting the breaker to the dimmer to force it to recalibrate it's settings. If that does not correct it, contact Technical Support for further assistance. adorne products 1.800.223.4185 opt 3 Mon - Fri: 8am - 6pm EST (excluding holidays) Email Us - tech.support@legrand.us

Yes, the ADTP703TUM4 is rated to handle ELV loads, where the Paddle dimmer is not. This is from the Lumens spec sheet for your light: Dimmable When Used With a Electronic low voltage (ELV) Dimmer (Not Included)

The universal dimmer is designed to dim to approximately 3% of your light load but also depends on the low end restrictions of the LED bulb. Some only dim to 10%.

You should look into AAFN4S16AM4 see https://smhttp-ssl-40934.nexcesscdn.net/pdf/adorne-Install-AAFN4S16A_340966.pdf