adorne® Locator Status Light

The light IS inserted too far. It's not impossible to do as I spent an hour swapping switches thinking one was faulty everytime I put in the locator. In fact the instructions or the locator light are faulty - they don't give the right info or the stick is actually too long. If you push the light-stick all the way in so the "bezel" of the light is touching the back of the switch housing (as you would expect to do) the light somehow touches something in the paddle switch and gets in the way so that the switch loses it's "CLICK" when turned on/off. Once the stick is backed out 1/8" or so the switch-click will come back. Hopefully the instructions for this product or the design will be revised - seems like it wasn't ever tested. PS - It's really really a nice feature, and well worth the couple bucks extra, just needs the kinks worked out.

The Brightness of the locator light can vary slightly based on the load being controlled. Feel free to contact tech support at 1800 223 4185 Option 1

Thank you for your question regarding the installation of the adorne Status Locator Light(Model # AALSL6). Here is the required wiring for each application: Single pole - connect leads to HOT & 1POLE 3Way - connect leads to 1POLE & 3WAY 4Way - connect both leads to IN or both leads to OUT adorne products 1.800.223.4185 opt 3 Mon - Fri: 8am - 8pm EST (excluding holidays) Email Us - tech.support@legrand.us

Thank you for your inquiry regarding our adorne locator light. In a 3 way, the indicator light blue wires are going to go in the 1 pole and 3 way terminals. In a 4 way paddle, the blue wires will go into the either both of the in terminals or both of the out terminals. Hope this helps!

Some LED lights are sensitive to the leak through current that illuminates when the switch is in the OFF position, where incandescent bulbs are not. You can try wiring the Locator lights leads to the 3way terminal and a neutral wire.