High/Low PIR Integrated Outdoor Fixture Mount Sensor
FSP-211-CFG
Wattstopper
Bazaarvoice SAP Hybris Integration Version 2.8.1
The FSP-201 mounts in an outdoor lighting fixture and provides multi-level control based on motion and/or daylight contribution. It controls 0-10 VDC dim-to-off LED drivers or ballasts, or works with a power pack to control other loads. When used with an FSP-Lx Lens, the sensor is rated for wet and cold locations. All control parameters are adjustable via a wireless configuration tool capable of storing and transmitting sensor profiles.
Voltage
None
- 12 V
- 120/277 VAC
- 347 VAC
- None
- Send
- Save as PDF
-
Added to Favorites Go to favoritesRemove from favorites?Something went wrong. Please try again later.
Features
- Fully adjustable high and low dimmed light levels; optional dusk to dawn control
- Controls 0-10V dim-to-off LED drivers or ballasts, or works with a power pack to control other loads
- Hold off setpoint with automatic calibration option for convenience and added energy savings
- Adjustable via handheld wireless configuration tool
- IP66 rated with choice of lenses for wet and outdoor locations, and mounting heights from 8’ to 40’
- Adjustable time delay and cut off delay
Specifications
General Info
Product Line | Wattstopper | ||
UPC Number | 754182940981 | ||
Country Of Origin | China |
Additional Information
Product Environmental Profile | Yes |
Technical Information
Sensor Type | Daylight, Occupancy |
Resources
Product Environmental Profile
Installation Instructions
Instruction Sheet
Reviews
Bazaarvoice SAP Hybris Integration Version 2.8.1
Questions & Answers
Is it possible to get a 3-D cad model of the FSP-221
The nature of this request is best addressed by an application specialist, we cannot post CAD files in this forum. Please contact Wattstopper Technical Support @800-879-8585 so that your request can be directed through the proper channels.
Date published: 2022-06-13
IS it possible to have a 3D model or DXF drawing of the FSP-201? Thanks for the support
Below is a CAD drawing for the FSP 201 to give you some answers to your question.
Date published: 2022-05-23
What is the default position for the FSP-211, if it were to fail at EOL? Would the light default on or off?
Whether it fails in the ON or OFF state depends entirely upon the mode of failure, so we cannot state that it will always fail in a particular state.
Date published: 2022-11-11
Bazaarvoice SAP Hybris Integration Version 2.8.1