DLM Zone Controller, Scheduler and Network Interface
LMZC-301
Wattstopper
Bazaarvoice SAP Hybris Integration Version 2.8.1
The LMZC-301 zone controller provides power and connectivity to Digital Lighting Management (DLM) fixture controllers as well as switches, occupancy sensors, daylight sensors, and input modules. It is the foundation of a DLM local network for fixture controllers, and includes integral segment network connectivity. The zone controller can be used to enable the automation of lighting functions across a facility.
- Send
- Save as PDF
-
FavoriteAdded to Favorites Go to favoritesRemove from favorites?Something went wrong. Please try again later.
Features
- Runs scheduled and photocell events autonomously
- Easy setup via LMCT-100-2 handheld configuration tool
- Ideal power supply for DLM fixture controllers; supports up to 64 connected loads
- Native BACnet communications for network control solutions
- 99 control groups accessible via handheld configuration tool
- Compatible with Digital Lighting Management load controllers, switches, sensors and input devices
Specifications
General Info
| Product Line | Wattstopper | ||
| UPC Number | 754182938674 | ||
| Country Of Origin | United States |
Additional Information
| Security | Yes | This product is ioXt certified |
Resources
Cutsheet
Instruction Sheet
Installation Instructions
Reviews
Bazaarvoice SAP Hybris Integration Version 2.8.1
Questions & Answers
OurLMZC-301 seams to have lost the photocell input, that controls it. I have a LMCI-100 to look at the device, but dont't know if i'm connected correctly, because I can't see anything. Please advise
Hello, the LMZC-301 is compatible with our LMCS software. You can find the direct download on our website Legrand.us, once downloaded we can use a cat5e cable between the A/B ports on the LMZC to the LMCI, then USB to Laptop. Once connected, at the bottom right it should show "connected".
If further assistance is needed please call Wattstopper Tech Support 1-800-879-8585
Date published: 2022-07-06
How does the cable between an internally-mounted LMPB-100 and the "A" RJ45 port need to be?
It is a standard cat6 cable and needs to be 8-12" long.
Date published: 2022-06-09
on the LMZC, are there any issues with using LMPD port 3&4 instead of 1&2
The LMZC-301 has four LMPD ports which are use to power up the LMRD board on a panel. The only reason there a four is because the maximum amount of LMRD boards on a panel is four so it doesn't matter which one you use they all work the same.
Date published: 2021-08-16