Dual Tech Wall Switch Occupancy Sensor, 347V, Ivory

Hello, DSW-301-W supports the following Multi-way features: (Total of 4 Sensors) The Multi-Way capability is available on all models. Sensors can easily be wired together for convenient control of a common load. When wiring this way, only use 300 series sensors. Multi-Way in 300 series is not compatible with prior sensor models. The following principles apply for Multi-Way: • All units should be on the same phase. • All units can see each other’s push-button events and respond accordingly. • All units can see each other’s PIR trigger event. The response will be determined by the Light Level setting and/or conditions of the space of the detecting sensor. • The time delay for all units is defined by the unit with the smallest time delay Best Regards, Technical Support

The lens is not available as an individual part. Please contact Wattstopper Technical Support for further information. 800-879-8585.

Reset to Default Use the DIP Switch Settings tables shown below to return features to factory settings. To reset the DSW, press and hold the Relay 1 button for 10 seconds until a triple beep sounds. This resets the sensor and disables light level control (the brightest ambient light will not hold the light OFF).