802.11n In-Wall/Ceiling Wireless Access Point
802.11n In-Wall/Ceiling Wireless Access Point is rated out of 5 by 2.
This 802.11n indoor access point installs elegantly into the ceiling or wall to distribute a fast, reliable WiFi signal throughout the home. Install the access point in a central location of the home to maximize coverage.
- Delivers speeds up to 300Mbps
- Ships with ceiling and wall covers, installation instructions, and user guide
- Backwards compatible with the 802.11b/g standards (11Mbps/54Mbps)
- DA1101 units shipped in September 2012 (manufactured date code of 3512) and later have both Midspan PoE support and PoE switch compatibility (802.11af/at)
- Download the most recent firmware update here
|Countries Of Origin||Taiwan, Province Of China|
|RoHS Conformant||Yes||This product meets the material restrictions of Article 4 of the RoHS Directive (2011/65/EU), including Commission Delegated Directive 2015/863.|
|Data Transfer Rate||300 bps|
|Compatibility||IEEE 802.11 n, backward compatible with 802.11b/g (11 Mbps/54 Mbps)|
|Number of Ports||32|
Rated 5 out of 5 by Mikeh69 from Fantastic Ok. Funcionment. Prize ok assistant good. Legrand contact ok
Date published: 2019-09-23
Rated 2 out of 5 by Rink from Connect to Device App is terrible To make adjustments to this product you must download the 'Legrand Smart Discovery" app which lets you find the Access Point on your network. Fine - that works as expected. However, once you try to 'connect to a device' that is on your network, that app itself crashes constantly, fails to save any changes once you try to make any, and just errors out at any point where I try to send a request to the Access Point itself. I tried updating the firmware of the device, assuming that might be the issue, and now that I have updated the firmware, the Smart Discovery App cannot find the Access Point and now I am stuck with a pointless Circle mounted to my upstairs ceiling hallway with no way to interact with it.
Date published: 2019-03-01
So this takes the signal from my router and distributes it thru out the house? You need to link your router and this product together? I need some clarification, if someone could assist?
Hello, Yes you would need to provide a CAT5/6 run from your router to the access point. It would then provide a wireless signal to connect through the house. The device can also be used as a repeater as well but generally, it functions primarily as an access point out of the box. Thank you.
Date published: 2018-11-14