radiant® Horizontal Step Light

You can put duct seal over the sensor. Then use switch. Not designed for dimmers, but I've used lutron RA2 RRDPRO dimmer and has worked ok for 2 months now.

The horizontal nightlight has adjustable light levels(ultra low, low, med, and high). It is not designed to be controlled by a dimmer or switch seeing the built-in light sensor will turn it on automatically but sensing the light level in the room.

Lumens with louver: Extra Low - .6 Low - 2.3 Med - 4.9 High - 9.0 Without louver: Extra Low - 1.7 Low - 6.8 Med - 16.1 High - 30.4

The wallplates are sold separate and the one shown in the picture is our RWP26W(screwless wallplate).

They are designed for indoor use only.

Thank you for your inquiry. You are using the correct plate for that device. If you are having trouble installing it, please contact technical support at tech.support@legrand.us or by phone at 1-800-223-4185.

Currently, the louvers are not sold separate but if you contact Technical Support they can assist you with getting the louvers you need. Radiant products 1.800.223-4162 opt 3 Mon - Fri: 8am - 8pm EST (excluding holidays) Email Us - tech.support@legrand.us

These are turned on/off by a photo sensor built into the lights themselves. I wouldn't suggest for them to be controlled by a switch. I would suggest the TMHWLLOUVCC for that purpose. These don't have a sensor and can be wired to a switch. You would use a louvered plate of your choice to go over it. https://www.legrand.us/passandseymour/nightlights/full/tmhwllouvcc.aspx Hope this helps!