Flexcor® Support Grips Standard Duty, Split Lace, Offset Eye, Cable Diameter 1.50 - 1.74 in.

FS150OF: Standard Duty, Split Lace, Offset Eye, Cable Diameter 1.50 - 1.74 inches, Bale Length 5-in, Mesh Length 18-in

Send
Save as PDF
Added to Favorites Go to favorites

Remove from favorites?

Something went wrong. Please try again later.

Features

Split lace support grips are used when the end of the cable cannot easily be accessed and the support grip is intended for permanent installation.
Split lace support grips are designed for loads up to 600 lbs.
Vertical runs of no more than 100 ft.
They are available in a variety of eye styles and cable ranges for supporting electrical and fiber optic cable, metal rods, and tubing.
Support grips are woven of corrosion-resistant tinned-stainless steel wire.
Most Flexcor products have UL and/or CSA approvals. Please contact factory for approval information.
Bale Length: 5: Mesh Length: 18

General Info

Type	Support Grip
Application Sector	Industrial
Product Line	Pass & Seymour
Country Of Origin	Mexico
Construction	Various Types of Pulling, Support and Strain Relief Grips
Standard	UL/CSA Approval (consult factory)
UPC Number	785007983890

Dimensions

Cable Diameter Range	1.50-1.74 in
Mesh Length	17 in

Technical Information

Approximate Break Strength	1500 lb
Eye Style	Offset
Mesh Type	Split Lace
Capacity	Various Cable Diameter Ranges
Indoor/Outdoor	Both
Maximum Cable Range	1.5 in
Minimum Cable Range	1.74 in
Mounting	Consult the Factory for Mounting Recommendations