Open Loop Multiple Zone DLM photosensor

When configured for Dimming Mode, the LMLS-500 will not switch the fixture off—it only dims the light output to maintain the desired light level. DLM LMLS photosensors can be configured in four modes: Switched, Bi-Level, Tri-Level, or Dimmed. 🔹 Switched – Turns lights fully on or off based on daylight levels. 🔹 Bi-Level – Provides two output levels (high/low), often occupancy-based. 🔹 Tri-Level – Adds an “off” state after an extended unoccupied period. 🔹 Dimmed (Continuous Dimming) – Continuously adjusts light output to maintain a target light level. When daylight increases, the lights dim; when daylight decreases, they brighten. The minimum dim level can be configured so lights never turn completely off. If lights are turning off unexpectedly, confirm the device is set to Dimmed Mode. Please contact Wattstopper Technical Support for further assistance if needed.

It can be painted, but do not get any paint on the lens.

Please reach out to our tech. support team for further assistance with this question and explore sensor options. A LMLS-400 might be a better choice in this case for a single zone. Legrand Technical Support: Phone: 1 800-879-8585, Option 3 then Option 1 Mon - Fri: 7am - 7pm CST (excluding holidays)